ledlenser P6R Signature, Руководство пользователя

Страница: 6 / 12

6
2.
1.
<3s
<3s
4
5
+1x
+1x
1x
+1x
EN - User Manual P7R Signature / P6R Signature V.01 03.2021
4. To remove the rechargeable battery, the end cap of
the lamp is screwed off. The battery can then be
removed. When inserting a new battery, pay attention
to the correct polarity (+/-). This is marked on the
battery and inside the lamp shaft. Only approved
batteries may be used. Then close the lamp again by
screwing the end cap on. To ensure watertightness,
make sure that the seals are undamaged.
5. This lamp has several light functions or brightness
levels. This lamp also offers a MODE SWITCH with
four positions. Depending on the position of the
mode switch, various light functions can be reached
quickly.
The desired function can be selected within the first
three seconds after switching the lamp on. To do this,
first switch the lamp on and then tap the switch once
within three seconds to switch to the next function.
If the switch has not been pressed for more than
three seconds or if the last available light function
has been selected, the lamp switches off the next
time the switch is pressed.
When the lamp is switched on, the remaining battery
capacity is displayed (
GREEN fully charged; ORANGE
half full; RED almost empty)
If the „Memory Mode“ is active, the lamp always
turns on with the previously selected light function. If
the „Memory Mode“ is deactivated, the lamp always
starts with the same light function. The „Memory Mode“
can be activated and deactivated in the advanced
settings (10).
MODE SWITCH | Position 1
Light modes: Power, Mid Power, Low Power
Battery Replacement
Off
Off
Power
Mid Power
Low Power
Default Operation
MODE SWITCH
Position 1