www.prolight.co.uk
VersiMove 24 DMX Controller
User Manual
7
e.g. If your fixture’s dimmer channel is number 5 then rotate the “tilt wheel” to show 05 on the display,
now press “enter” to confirm. Now rotate the “pan wheel” to show number 02 in the display, this is
fader 2 the “red” channel. If for example your fixtures red channel is DMX channel 3 then rotate the tilt
wheel to show 03 in the display. Now press the Enter button to confirm.
For any unused channels, you can hit the “Blackout/Delete” button to change the channel value to
“NULL”. This will allow DMX fixtures to be patched based on the fixtures DMX channel count and allow
you to utilise the full 24 available fixtures if required.
Now continue using the same process until all of the DMX channels on your fixture have been assigned.
Don’t forget, Pan & Tilt should be assigned to numbers 25 and 26.
Continue the same process for each fixture until all of your fixtures have been patched into
the controller.
During the above patch process, it is possible to reverse the action of any fader (e.g. for shutter chan-
nels) by pressing the swap button, use the Tilt wheel to change. A second press of the swap button will
enable or disable the fade in/out time of the fixtures colour channels just rotate the pan wheel left/right
for yes or no.
If you have 2 or more of the same fixture you can patch the first fixture and then copy to a second fixture
number by holding down the fixture button for three seconds and while keeping the button pressed you
can press the fixture button you wish to copy too. The display will confirm that the copy has taken place.
When you have finished all the patching press the “ESC” button to exit.
Saving scenes:
Press and hold the REC/Enter button to go into Program mode, then press the Scene button to
illuminate its LED. Now select a fixture, then using the faders setup the fixture to the desired setting.
Next select the Bank (A, B or C) using the Scene Page button you can then press the REC/Enter button
once. At this point the LEDs next to the number buttons will illuminate to show any existing scenes. Now
press the number button of the next available scene (unlit number button), when you do this all LEDs
will flash to register the save. Repeat this process and when you have completed saving your scenes
(maximum 36 scenes), press and hold the REC/Enter button to exit the program.
Saving chases:
Press and hold the REC/Enter button to go into Program Mode, then press the Chase Button.
Now press one of the number buttons in which to save your chase. The display will now show the
chase number and the step number, adjust your lighting fixtures to the desired setting then press the
REC/Enter button. All the LEDs will flash and the step number will increase by one. Continue in this way
until your chase is complete, then press and hold the REC/Enter button to exit the program mode.
Deleting scenes:
Press and hold the REC/Enter button to go into Program Mode, then select the Chase/Scene using the
Page/Chase/Scene buttons (individual steps maybe selected using the PAN jog wheel). After selecting
the desired Step, press and hold the Blackout/Delete button, upon releasing the button all of the LEDs
on the controller will flash to confirm the step has been deleted.
Operating instructions
