www.prolight.co.uk
Event Spot RGBW MKII
User Manual
9
Operating instructions
Optional IR remote functions:
Button functions:
DMX address examples:
Important notes:
•
Set the DMX address on each fixture before plugging into the DMX controller
•
The IR remote cannot be used when the fixture(s) are being controlled with a DMX controller
•
The maximum IR transmitter distance is 10m - Please make sure that you have the IR remote
aimed directly at the front panel of each fixture to be programmed
•
If you do not press the “DMX MODE” button after you have changed the DMX address when you
power down the fixture it will lose the address you have set
01 - Sets the LEDs into power on or off modes
02 - Runs the built-in programs, use the ‘+’ and ‘-’
buttons to go through the programs
03 - Sets the LEDs to flash on and off, use the ‘+’
and ‘-’ buttons to change the flash frequency
04 - Sets the run speed, use the ‘+’ and ‘-’ buttons
to change the desired speed (note: only available in
the colour change or colour fade modes)
05 - Sets the LEDs into DMX mode
06 - Sets the LEDs into sound active mode
07 - Sets the LEDs into slave mode
08 - Sets the DMX address for the LEDs
09 - Sets the LEDs colour, then use the ‘+’ and ‘-’
buttons to change the brightness
1 2 3
4 5 6 0
+
_
7 8 9
AW
D
FL
SL
SP
S
S PR
SA
R
G
B
BLACKOUT
DIMMING
FLASH
SLAVE
SPEED
SET ADDR
SELECT PROG
SOUND ACTIVE
AMBER/WHITE
DMX MODE
02
01
03
09
09
04
06
07
05
08
To set the DMX address “245”;
•
Press the “S” button, the red LEDs will come on,
you can now start to set the DMX address
•
Now press the “2” button, the green LEDs will
come on, this means the first digit has been
set at 2
•
Now press the “4” button, the blue LEDs will
come on, this means the second digit has been
set at 4
•
Now press the “5” button, and the white/amber
LEDs will come on, the third digit 5 has been set.
The full DMX address setting has been changed
•
Now press the “DMX MODE” button to save
the new address into the memory
To set the DMX address “002”;
•
Press the “S” button, the red LEDs will come on,
you can now start to set the DMX address
•
Now press the “0” button, the green LEDs will
come on, this means the first digit has been
set at 0
•
Now press the “0” button, the blue LEDs will
come on, this means the second digit has been
set at 0
•
Now press the “2” button, and the white/amber
LEDs will come on, the third digit 5 has been set.
The full DMX address setting has been changed
•
Now press the “DMX MODE” button to save
the new address into memory
Optional
IR remote
Order code:
LEDJ90C
