7.
Be sure to mount the control box in a secure and dry location. We recommend mounting it under the seat or in a water
tight compartment, if possible. If this is not possible, we suggest mounting the control box in the driest location
available.
8.
Connect the red power wire from the control box to the positive terminal of the battery. If the power wire needs to be
extended, be sure to use 16 or 18 gauge automotive grade wire. Be sure to reinstall the fuse within 6 inches of the
battery. Connect the black ground wire to the negative terminal of the battery.
9.
The kit was designed using a modular locking plug system for connecting the motorcycle lighting strips to the control
box by using the included power harness. Start plugging the male connections from the strips and control box into the
female connections of the power harness.
Do not shorten or cut any wires, you will void the warranty.
10.
You can now test the kit for full functionality by pressing the on/off button on the wireless remote. If you removed any
trim for this installation, you can now reinstall them.
11.
For more information, please refer to our instructional videos that can be found at
Wireless Remote Functions:
This kit provides multiple lighting patterns and several brightness levels, which are easily operated using the included
wireless remote. The remote includes four buttons, “A, B, C, D”
Button A:
Cycles through 15 solid colors, as well as a color cycle and a color fade pattern.
Hold for 5 seconds to select brightness level when on a solid color.
Button B:
Activates strobing pattern when a single color is selected.
Hold to increase pattern speed when on color cycle/color fade pattern.
Button C:
Activates fading pattern when a single color is selected.
Hold to decrease pattern speed when on color cycle/color fade pattern.
Button D:
Power On/Off
Reprogramming the Wireless Remote:
This procedure is going to be used for programming an existing or a brand new wireless remote to the control box. If
the control box is currently connected to power and ground, please temporarily disconnect the ground wire from the ground
source. Reconnect the ground wire back to the ground source and once this is connected, the lights on the strips will turn on
green. Within 5 seconds from when the kit turns on green, you can press the A and then the B button on the wireless remote. If
this programming was successful, the light strips will flicker green twice and the kit will remain powered on. If the remote is not
controlling the system, please repeat the steps above.
Troubleshooting:
If the kit or lights do not appear to be operating properly, first check the installed inline mini fuse. If the fuse is blown,
check the wires on the entire kit to ensure they are not cut, pinched, or scorched. If there is no damage to any of the wires and no
visible water damage to the control box, replace the fuse and test the kit again. If the inline fuse is intact, clean both the positive
and negative terminals of the battery. Corrosion to the battery terminals can cause a poor connection or simulate being
disconnected.
For accessories, add-on kits, replacement parts, and/or Technical Support, please visit
