1
301 Thor Place, Brea, CA 92821 |
tel
(714) 256-2111 |
fax
(714) 256-2118 | [email protected] |
www.ledconn.com
Details are subject to change without notice. © 2019 LEDCONN CORP. All Rights Reserved.
IG.20.01.R0
I N S T A L L A T I O N G U I D E
SCAN FOR
DIGITAL VERSION
Thin, flexible LED sheet for backlighting small and large format projects alike. Cuttable, crosswired solution with easy to
use Molex connectors for the perfect application fit. Available in multiple color temperatures—which include static white
(LUXFLEX Premium/Standard) and RGBW—and compatible with a wide array of dimmers & controls.
For your safety, please read and understand instructions completely before starting installation and retain this guide for
future reference.
HANDLING & MOUNTING
SEALING SHEETS
FOR OUTDOOR &
DAMP LOCATIONS
MANAGING THE PRODUCT
• Cutting sheets will expose copper electrical wires and
conductors that become non insulated when they are cut. This
raises the likelihood of electrical shorting between connectors
and compromised lighting quality. To avoid this, allow for a 1-2mm
spacing between sheets and cut pieces and do not touch any
conducting metal components.
• Dry fit flexible sheets before installing.
• Mock up LED flexible sheet with face material to ensure desired
effect is achieved.
• Avoid repeated twisting, folding, creasing, or flexing of LUXFLEX
sheets.
• Do not scrape or use excessive rubbing force on LUXFLEX sheets
• LUXFLEX is a flexible light emitter. Do not bend the light sheets to
less than a 3" diameter.
• LUXFLEX sheets can be damaged by electrostatic discharge.
Observe precautions for handling electrostatic sensitive devices.
• Make sure to provide a minimal airgap to prevent hot spots.
• Avoid placing heavy objects on LUXFLEX.
• No heat sink is required for installation.
AIRGAPS
• 3-4" Recommended airgap between product & substrate,
depending on face material opacity for optimum backlight
evenness.
GENERAL MOUNTING GUIDELINES
• Install the flexible sheets panel in accordance with project
specifications or consult a designer.
• Consult Architects, General Contractors, or Fabricators for
recommendations when field conditions require modifications to
approved submittal or mockup.
• Do not mount or slide heavy objects onto flexible sheet.
• If flexible sheet needs to be repositioned, remove fasteners and be
sure new mounting holes do not overlap with prior holes.
• If flexible sheet is mounted with adhesive, pull up instead of sideways
to lift flexible sheet.
• Please note that handling and mounting the product is the installer's
responsibility. LEDCONN assumes no responsibility for the installation
of the product and assumes no liabiity for any installation or
reinstallation costs.
• For cut pieces of LUXFLEX requested for damp location usage,
add on silicone to exposed conductors. See "Prepping for Outdoor &
Damp Locations" below for best practices.
OPTIONS
• 3M Adhesive Tape • Fastener (screws)
REQUIRED PARTS FOR INSTALLATION
• Molex to hardwire or DC barrel
• Molex to Molex connector (jumper cable/tiling connector)
• Fastener screws
1
2
Apply silicone seal.
Make sure the sealed
connection fully cures (dries).
ENLARGED VIEW
LUXFLEX can be used for outdoor
damp location environments when
Molex connections are properly sealed.
If sheets were not ordered with silicone
sealing, you may add it in the field.
INSTRUCTIONS
1. After testing that all lights are operational,
seal each Molex connection by applying water
resistant silicone to the connection.
2. Allow sealed connection to cure completely
before reconnecting to power.
LUXFLE X
™
Static White & RGBW
FLEXIBLE SHEET
