www
.
LED
tronic
s
.c
om
Brackets Installation
© 2010 LEDtronics, Inc.
LED
TRONICS, INC.
®
THE FUTURE OF LIGHT
9001:2000
ISO
CERTIFIED by DNV
INSTR-SLL003P
-0001-E / R
ev
. 02/2011
Yoke Bracket
SLB003P-FL73LY-001
Direct-Mount
Pole Arm
SLB003-FLAM-001
Swivel Bracket
SLB003-FL73BR-001
®
Use O ring between housing and bracket.
■
Use long bolts to mount bracket to luminaire
■
housing.
Use 2 additional bolts to act as a stop on both
■
sides to the bracket and to provide the desired
angle for surface mounting
Remove screw plugs
■
and follow diagram
at right
Screw
1.
Spring washer
2.
Flat washer
3.
Yoke washer screw
4.
Cover for Yoke
5.
Yoke
6.
Yoke Screw
7.
Nut
8.
Open luminaire lens by
■
removing 4 screws.
Remove outside of cord grip
■
by sliding an adjustable
wrench on the inside. With
an additional wrench on the
outside, rotate to loosen.
Remove only the outside of
cord grip. Leave inside of
cord grip located inside the
luminaire.
Reinstall luminaire lens with
■
4 screws.
Remove 4 screws and open
■
flat luminaire side of arm.
Peel paper off of square
■
gasket material and place
over luminaire mounting
area.
Send power cord through flat
■
luminaire side of arm.
Mount arm onto luminaire
■
enclosure with 2 screws
provided.
Remove 4 screws and open
■
curved pole side of arm.
Send power cord through
■
swivel middle section of arm
to curved pole side of arm.
Peel paper off of square
■
gasket material and place
over curved pole mounting
area of arm.
Close flat side luminaire arm
■
by replacing four screws.
Mount luminaire and arm to
■
desired pole location with
provided 2 screws and nuts.
Send power cord through arm
■
and through pole.
Flat Luminaire Side of Arm
Inside of Both Arms
Curved Pole Side of Arm
PAGE 2
1
7
2
8
5
3
4
6
‘O’ ring
between
housing and
bracket
screw acts as
stop for bracket
