LED Strip Studio LEC3, Руководство пользователя

Страница: 12 / 43

12
LEC 3 - Front Connectors
LEC 3 front view
Ethernet
Status
Buttons
IP/DMX Add.
SD-card
DMX In/Out IC
DMX LED
To control Ethernet board using LSS software you have to
connect your PC with Ethernet board using Ethernet cable.
Three LEDs which show device status:
Green – power is on
Yellow – DMX or ArtNet is present
(fast blink for DMX, slow blink for ArtNet)
Red – if on, LSS software is connected to the device
over Ethernet
Allows you to select file to play in auto-play mode and also
to run test patterns (in case the SD card is not inserted).
The reset button sets the device to factory default settings
DIP switch allows you to set IP and DMX address.
In auto-play mode can be used to set animation to play.
FAT32 micro SD-card for storing LED videos/animations.
You can trigger them using DMX, ArtNet or use them in
auto play mode.
You can use DMX In/Out to control LEC3 or LSS software.
DMX out can work in through or output mode
(it’s a bit more advanced comparing to standard DMX).
Indicates, whether the DMX is in though mode
(typically in DMX control mode).