mixers. With 8 NOM busses, up to 8 separate mixers can be configured with the AM16/12. If an input is assigned to
“None”, it will neither affect any other channel’s automatic gain or be affected by another channel.
Short Cuts:
A left mouse click on the NOM box will associate the input with NOM bus 1, while a right mouse click will
set the association to “None”.
On LED
- Indicates that the attenuation applied to the input as a result of the automatic mixing action is less than
6dB. For inputs in the Direct mode, or inputs whose NOM assignment is “None”, this LED is always lit.
Level Meter
- Indicates the inputs level, taking into consideration the Input Gain, and the front and rear panel gain
contributions.
Input Tone Tab
The Input Tone tab allows the low
cut frequency and the high
frequency cut or boost to be set
for each of the 16 input channels.
Low Cut
- Sets the low cut
corner frequency for each input
channel. The low cut filter is a
6dB/octave (i.e. single pole) filter.
Frequency choices are 75Hz,
90Hz, 110Hz, 130Hz, 190Hz,
280Hz, 600Hz, and Flat.
Short Cut:
A left click on the low
cut box causes the frequency to
be set to “Flat”.
Hi Cut/Boost
- Sets the high
frequency cut or boost for each
input channel. The inflection
point of the high frequency tone
control is approximately 1kHz.
Choices for cut/boost are -8dB,
6dB, -3dB, Flat, +3dB, +6dB, and
+8dB.
Short Cut:
A left click on the hi
cut/boost box causes the cut/
boost value to be set to “Flat”.
14
