Lectronics Venue 2-941, Руководство по установке, Страница: 11 / 32

Digital Hybrid Wireless ® Modular Receiver System
Rio Rancho, NM, USA
11
Using Setup Screens
When a menu item is selected, a setup screen will
open to enable adjustments and settings to be made.
The setup screen may be for a simple, two-state set-
ting like Lock/Unlock, or may provide a display that
allows scrolling through the available receiver modules
and options, or include multiple settings. Examples of
the various screen types are presented below.
The Lock/Unlock screen is typical of the single item
screens. Simply press the encoder to highlight
EDIT,
then rotate the encoder to select the value or setting.
Press the rotary encoder to highlight the EDIT function and
rotate the encoder to change the value.
Multiple item setup screens like the
Smart NR (Smart
Noise Reduction) example below allow scrolling
through the options in a “stacked” arrangement.
In this example, rotate the encoder to point at
CHOOSE RX, then press the encoder to highlight it.
Rotate the encoder to select the desired receiver.
After selecting the receiver, press the encoder and ro-
tate it to select EDIT. The noise reduction mode will be
highlighted. Rotate the encoder to the desired mode.
NOTE: The RX and TX Menus present multiple
item setup screens like the above example,
where the same setting can be made on multiple
channels. Some setup screens in the Top Menu
allow scrolling through multiple parameters in the
same manner as the above example.
The
FREQ ADJUST setup screen in the RX Menu
shown here is another type of a multiple module setup
screen. The difference from the previous example is
that this type presents multiple settings within each
receiver setup screen.
When the setup screen opens, a “stack” of the installed
modules will be presented.
Top bar lists the current menu and screen
CHOOSE RX allows scroliing
through receiver “stack”
EDIT allows frequency to be
changed on selected receiver
Rotate the encoder to select
CHOOSE RX and press
the encoder to highlight it. Rotate the encoder to select
the desired receiver module.
After the module is selected, press the encoder and
rotate it to select EDIT and press the encoder to
highlight it. Rotate the encoder to select the item to be
edited within the selected module.
The item to be edited is
enclosed in brackets
EDIT function highlighted
After the item is selected (brackets) press the encoder
to highlight it and rotate the encoder to adjust the set-
ting or value.
Item is highlighted for adjustment