Lectronics Digital Hybrid Wireless HHa-941, Инструкция по эксплуатации

Страница: 8 / 20

HHa
LECTROSONICS, INC.
8
Battery Condition
An icon on the
Main Window
indicates the remaining
power of the transmitter batteries. This battery gauge
is most accurate with the typical voltage drop across
the life of alkaline batteries.
5
950.500
-40 -20
0
A
Battery Gauge
Rechargeable batteries give little or no warning when
nearing depletion. If you use rechargeable batteries
in the transmitter, we recommend trying fully charged
batteries first, noting the length of time that the batter-
ies will run the unit using the battery timer function in
the receiver. Then use the timer function during opera-
tion to view the elapsed time.
Navigating Menus and Screens
The Main Window displays the following information:
5
950.500
-40 -20 0
A
TB
Hex Code for
Operating frequency
Icon indicates
whether RF output
is turned on or off
Battery condition
Operating
frequency in MHz
Audio level
Function of the
rear panel switch
(talkback button)
1) Press the
MENU/SEL
button to enter the setup
menu. Use the UP/DOWN buttons to highlight the
menu item.
2) Press the MENU/SEL button to enter the setup
screen for that item. Use the UP/DOWN buttons
to select the desired value or mode.
Gain
Freq.
ProgSw
Rolloff
-40 -20
0
Gain
25
3) Press the
MENU/SEL
button to save this setting
and return to the previous screen.
4) Press the BACK button to return to the Main
Window
.
Powering Off
Press and hold the
Power Button
(or the side but-
ton if it is configured for turning the power on and off)
for several seconds and observe the LCD countdown
progress from 3 to 1. The power will then be turned off.
This can be done from any menu or screen.
Powering
Off . . .
1
NOTE: If the Power Button
is released before the
countdown is completed, the
unit will remain turned on
and the LCD will return to the
same screen or menu that
was displayed previously.
Standby Mode
A brief push of the
Power Button
turns the unit on and
places it into a “standby” mode (not transmitting). This
allows the transmitter to be set up without the risk of
creating interference for other wireless systems that
are operating in the vicinity.
A notice will appear briefly confirming that the RF
output of the transmitter is turned off, followed by the
Main Window
. The antenna symbol will blink as a
reminder that the RF output is turned off.
5
950.500
-40 -20 0
A
MUTE
Symbol blinks
when RF output
is turned OFF
Rf
Off
Power Menu
Resume
Pwr Off
Rf On?
Backlit
When the transmitter is turned on, a
brief push of the Power Button will
reveal a menu listing the functions
shown below. Use the UP/DOWN
buttons to select one of the menu
items, then press the MENU/SEL
button to confirm this action.
• Resume: Continue operating in the same condi-
tion as before.
• Pwr Off: Turns off the transmitter.
• Rf On?: Begin transmitting the RF signal, enters
another screen prompting a
Yes
or
No
answer.
• Backlit: The LCD includes a backlight that il-
luminates the display for easier viewing. It is set
to come on when any button on the control panel
is pressed, then stay on for either 30 seconds or
5 minutes, or to stay on all the time.
• About : Displays the model, firmware version,
frequency block and compatibility mode.
The unit can also be turned off from any menu or
screen on the LCD by holding the power button in for
the duration of the countdown.