Lec TF6096W, Руководство пользователя, Страница: 15 / 20

7
GB/IE
Instruction for use
Outside cleaning
•
Clean the outside of the appliance by using
a sponge dipped in warm soapy water then
wipe with a soft dry cloth.
•
The cleaning of the outside of the
refrigerating circuit (compressor, condenser,
connection tubes) will be done by using a soft
brush or the vacuum-cleaner. During this
operation, please take care not to distort the
tubes or pull out the cables.
Do not use scouring powder or abrasive
materials !
•
After finishing the cleaning, put the
accessories back in their places and plug the
appliance in.
Replacing the interior light bulb
Should the light fail, switch off at the socket
outlet and pull out the mains plug.
Insert a flat bladed screw driver in between
the lamp cover and lamp housing and prise off
the lamp cover.
Then ensure the bulb is screwed securely in
the bulb holder. Replace the plug and switch
on.
If the light still fails, obtain a replacement E14
screw-cap type 15 Watt (Max) bulb from your
local electrical store and then fit it
(Fig 10) .
Carefully dispose of the old light bulb
immediately.
Trouble-shooting guide
In case your appliance does not work
please check if:
•
There is an electricity failure.
•
Ensure the appliance is plugged in correctly.
•
The fuse is blown.
The temperatures are not low enough.
•
The doors were not closed properly.
•
The food prevents the doors from closing.
•
The appliance was not located correctly.
•
The appliance is too close to a heat source.
The inside lighting does not work while the
compressor is running.
•
The lamp is blown. Unplug the appliance
from the mains, take out the lamp and replace
it with a new one.
There is water in the lower side of the
refrigerator compartment.
•
The water drain groove is clogged.
There is water in the lower side of the
refrigerator compartment.
•
The water drain groove is clogged.
Red alarm light comes on
If the following error messages are displayed:
E0, E1, E3, E4 or E8 – a service engineer will
need to be called.
Until the service engineers visit, you can
continue the use the appliance, without the risk
of damage of the food.
The high temperature alarm for freezer
Is activated after 24 hours from an initial power-
up and if the air temperature for freezer is higher
than -7
0
C.The high temperature alarm will go off
if the freezer air temperature is below -9
0
C.
If the red led lights for a short time. This can be
caused by placing food into the freezer
compartment or because the door was left open
for a long time. Ensure the circulating fans are
not blocked by food or packing.
If the advice above has not solved the problem,
call customer service.
The follow ing are not defects
•
The rear side of the freezer is warm.. This is
normal, to prevent the build up of condensation
on the outside of the appliance.
•
Temperature differences of 2
0
C between the
display and the actual cabinet temperature is
normal.
14