8
RESET PROCEDURE
Press and hold the DOWN button on the Handset (part 3) until the desk reaches its
lowest height. Release the DOWN button. Press and hold the DOWN button again
until the LED display reads “RST” or about 10 seconds on non-LED handset models.
Release the DOWN button. Press and hold the DOWN button again until the desk
lowers a little bit more, slightly rises and stops. Release the DOWN button. Your desk
is now ready to use.
The desk base can be adjusted by pressing and holding either the UP or DOWN
button until the desired height is reached.
To program up to three presets (**Old models may have up to 4): Use the up/down
buttons to find a desired height, then press “M” followed by a number 1 - 3.
CAUTION
Once a Preset button is pushed, the desk will move to the programmed height (see
caution below).
Ensure there are no obstacles in the desk’s path, and that the desktop
is not touching any walls. Please also ensure that all cords are an
appropriate length to accommodate the change in height.
IMPORTANT:
You must RESET the desk prior to use.
Assembly
10
11
12
Turn the assembled desk right-side up. With at least two people, grab the DESK BASE
(not the desktop) and turn the desk right-side up. Adjust the pre-installed glides on
the Feet (part 2) as needed.
Plug the Power Cord (part 9) into a 230v outlet.
