Assembly
1
2
3
5
6
Lay out all components and hardware to ensure that you have all items listed on the parts
page. Slide the Control Box (part 7) off the Frame End-CB (part 3) and set aside.
Fully separate Frame End (part 4) from Frame End-CB (part 3). You will find the Centre Rails
(part 5) inside.
3
4
7
5
1
11
3
1
12
3
6
Place one of the Legs (part l) into the Frame End-CB (part 3)
ensuring that the bar (arrow) is on “top” in relation to the Leg
(part l).
Line up the holes on the Leg (part l) with the holes
on the Frame End-CB (part 3).
Using the supplied Allen Wrench, insert four (4) M6x14 Machine
Screws (part 11) through the holes in the Frame End-CB (part 3),
going into the Leg (part l) and rotate each screw just a few turns.
After all four (4) M6x14 Machine Screws (part 11) are inserted,
tighten all four (4) screws.
Do the same for the other Leg (part l) and the Frame End (part 4).
The Frame End-CB (part 3) should be placed on
the side of the desk where you plan to mount the
Control Box (part 7) and the Handset (part 8).
Slide the Side Bracket (part 6) into the Frame End-
CB (part 3). Insert two (2) M6x10 Machine Screws
(part 12) through the two (2) holes in the bottom of
the Frame End (part 3} going into the inserted Side
Bracket (part 6). Using the supplied Allen Wrench,
rotate each screw just a few turns. After both M6x10
Machine Screws are inserted, tighten both screws.
Do the same for the other frame end/leg assembly.
