step4:Install
handlebar
Press E(handlebar) into
the Q(Steering yoke), use
N(screw) and M(nut) to fix
it.
（
Note: place M(nut) on
the hexagonal hole side,
insert N(screw) to the
round hole side)
step5:Install
lazyback
Press and fix the
F(lazyback) on the
corresponding position on
the car body.
9
10
1. The installation and replacement of the batteries
in the remote control:
Direction for use
Use a screwdriver to remove the battery cover of the remote control, insert
two AAA 1.5V dry batteries in correct polarity. Close the battery cover and
fix it with the screw. (Battery replacement also according to the above steps)
1.All batteries should be inserted in the correct polarity.
2.Non-rechargeable battery cannot be recharged
3.Before charging, the rechargeable battery must be taken out from the toys.
4.Take out and properly deal with the dead battery. To avoid injury, please
keep kids away from the battery.
5.The direct contact between the positive and negative terminals may result
in fire or explosion. Avoid direct connect between the terminals.
6.Do not mix old and new batteries.DO not mix alkaline, standard(carbon-
zinc),or rechargeable(nickel-cadmium) batteries.
7.Only an adult who has read and understood the safety warnings can
recharge the battery.
+ A AA
-
AAA
DC1
.
5V
+
-
+ AA A
-
M
N
E
Q
F
2
.
Matching the frequency of car and remote control
See more details of the remote control please refer to the outer packing
box of the remote control.
step7:Power
connection
1
.Find the positive
polarity
the red port), then
(
Remove the plastic cover
from the red terminal
(attention: put it at the safe
place where far from the
children to prevent the risk of
asphyxiation) , Find the
positive electrode (the red
port showed by arrow in
figure), connect power port to
the red terminal.
2
.
Then install the seat.
positive polarity
positive polarity
red wire
black wire
red terminal
red terminal
step6:Take off the
seat
use tool to remove screw
from seat, and take off the
seat. Take out the charger,
instruction book and
remote control（optional）
inside.
