14
15
SensXtend Sensor Dock Screw and Wall Anchor Instructions
Note:
If the pilot hole is not large enough for the wall
anchors, enlarge the hole slightly instead of trying to
the claw end of the hammer to gently remove the
anchor if this happens.
Once the wall anchors are in place, align the screw holes on
the sensor dock with the wall anchors and insert the screws
with a screwdriver or drill. Be sure to tighten the sensor dock
enough so it does not move, but be careful not to over-tighten
and crack the sensor dock.
SensXtend Sensor Dock Screw and Wall Anchor Instructions
Determine where the sensor dock will be placed and use a
pencil to mark where the screws will be placed on the wall.
Use a screwdriver or drill to create a pilot hole (a hole smaller
than the wall anchors provided).
Once the pilot holes are created, press the wall anchors into
the wall. Tap the head of the anchor lightly with a hammer
1
2
3
4
4
