Operation
REMOTE
INPUT
BASS
CONTROL
TREBLE
CONTROL
BALANCE
CONTROL
VOLUME
CONTROL
INPUT
SOURCE
DIRECT
BUTTON / LED
H E A D P H O N E
OUTPUT
POWER
LED
STANDBY
BUTTON
S T A N D B Y M O D E
The LEAK STEREO 230 will be in standby mode when powered on. Power LED indicator on front panel will show dark red. Press the Standby button or the
aaa
button on the remote handset to bring LEAK STEREO 230 out of standby.
You can adjust the ‘auto standby’ function by pressing and holding the Standby button on the front panel until the LED blinks. A short press of the Standby button
then selects the Auto - Standby function as follows:
20 min Auto-Standby
The Power LED indicator flashes twice: Auto-Standby 20 minutes. The LEAK STEREO 230 will automatically go into Standby mode if there is no signal input
or operation for 20 minutes.
1 Hour Auto-Standby
The Power LED indicator flashes thrice: Auto-Standby 1 hour. The LEAK STEREO 230 will automatically go into Standby mode if there is no signal input or
operation for 1 hour.
Never Auto-Standby (Default)
The Power LED indicator flashes once: Auto-Standby Never. The LEAK STEREO 230 will not go into Standby mode.
V O L U M E C O N T R O L
Before turning on the LEAK STEREO 230, please check the volume level before playing the source. The volume control will remain at the level it was last set
at when the unit was put in stand-by.
You can adjust the volume knob on the front panel or press the volume button of the remote control to adjust the volume level as needed.
Press the MUTE button on the remote control to enter MUTE mode. Note: the selected input indicator flashes to show the amplifier is in MUTE mode.
P L A Y I N G M U S I C V I A A N A L O G U E I N P U T S
Connect the analogue signal of a source unit to the LEAK STEREO 230’s AUX1 or AUX2 input. Rotate the INPUT selector on the front panel (or press the INPUT
select key on the remote control) to select the AUX1 or AUX2 input. The selected input indicator will light and music will start playing.
P L A Y I N G M U S I C V I A D I G I T A L I N P U T S
Connect the coaxial SPDIF or optical (TOSlink) output from your source unit to the digital in COAX jack or the optical (TOSlink) input on the LEAK STEREO 230’s
rear panel. Rotate the INPUT selector on the front panel (or press the INPUT select key on the remote control) to select the COAX / OPT input. The selected
input indicator will light and music will start playing when signal is present.
Page 12
‘STEREO 230’
INTEGRATED AMPLIFIER
I N S T A L L A T I O N
-
O P E R A T I O N
-
M A I N T E N A N C E
STEREO 230
input
volume
POWER
bass
direct
treble
balance
COAX
AUX 1
AUX 2
PHONO
