Leaf LTHDMI88 / LTHDMI88E manual
Page 12 Of 16
The calibration process may take up to a minute or two and when finished, the
LEDs will display (green) the previously selected sources and zones.
5.3 Clear all connections / Global OFF
The following steps describe the manual operation required if using the press button
switches on the LTHDMI88 /E. Note that this process is not directly accessible by Leaf
TC3.
Hold the lower button
(B)
for 3 seconds to clear all connections and set the unit
to standby mode.
Standby mode will be indicated by one single pulsing green/blue LED.
5.4 Creating new input / output connections.
Press the lower button
(B)
to enter selection mode. THE SELECTION MODE
LEDS WILL BE BLUE.
Press the lower button
(B)
sequentially until the LED in the lower row
corresponding to the desired output (zone) is blue.
Press the upper button
(A)
sequentially until the LED in the upper row
corresponding to the desired input (source) is blue.
After a few seconds the connection will be made, and these LEDS will turn
Green.
Notes:
1. If neither button is pressed for an extended time (approx 10sec), the
display will revert back to display mode (displaying input/output
connections).
2. If in the third step above the upper button
(A)
is pressed until no BLUE
LED are displayed in the upper row, the connection will be cleared - i.e.
the output will be disconnected from the input.
Содержание LTHDMI88
Страница 1: ...LTHDMI88 LTHDMI88E ...
