The value of state is “0” and “1”,”1” means “open over-speed alarm”, “0” means “close over-speed alarm”.
Example: #CSBJ#80#0#
After sending command successfully, the tracker will return a message “config OK The Warning Speed Is: 80 Off”.
Time Zone Setup
Format: #896# E or W # time zone #
The value of state is “E” and “w”, ”E” means “eastern time zone”, “W” means “western time zone”.
Example: #896#E#8#
After sending command successfully, the tracker will return a message “config OK Set Current time zone as: E8”.
Note: The default time zone is GMT+8. So you need recover it to GMT 0 first with command “#896#w#8#”. Then you can
set your time zone accordingly.
Open GPS Signal
Note: Center number can send this command to open GPS. The tracker will begin to work with GPS signal. There is still
GPS signal even the tracker is shutdown.
Format: #810#
After sending command successfully, the tracker will return a message “config OK”.
Note: The default GPS signal state is open.
Close GPS Signal
Note: Note: Center number can send this command to close GPS. The GPS module will stop working and in this mode,
there will be less power consumption. There is still no GPS signal even the tracker is shutdown.
Format: #811#
After sending command successfully, the tracker will return a message “config OK”.
Pre-stored numbers Setup
Format
：
#711#password#phone number1# phone number2# phone number3# phone number4#
Note: phone no. 4 is the voice monitor no. and it cannot be the same one as center number or any other pre-stored
