Hardware
installation manual of the ES-DH series drives
15
Rotating the Motor via the On-board HMI
User
’
s can rotate the motor by the on-board HMI for test purpose. A motion generator has been built
inside the drive. To start the motion, first you need to setup the motion parameter such as motion
velocity, motion distance, acceleration and initial direction, etc. The detailed steps are shown in the
following picture.
Display Data:
“
Position Error
”
M
Press
“
M
”
key once to go into
the
“
Edit Parameter Mode
”
Initially it displays the
“
PA__00
”
and
the 1st (from right to left) digit is blinking
Press
“
”
3 times to
decrease the number
It displays
“
PA__28
”
to
indicates the parameter No. 28
ENT
It displays the low order digits of
the position error at Power-up
Press the ENT
”
key
Power-Up
The initial value is 0
Press the
“
ENT
”
key to start
the motion
Caution:
The motor will rotate 1
revolution CW and 1 revolution
CCW. Make sure the move part
will not hit anything.
Press
“
”
1 times to
increase it to 1
M
Press
“
M
”
key
It returns to the
“
Display Data Mode
”
The actual displaying data is dependent.
ENT
ENT
M
Press
“
M
”
key
M
Press
“
M
”
key
Auxiliary Function: Reset Drive
Write to EERPM
Rotating the Motor by Motion Controller
You can start the controller or pulse generator to rotate the motor. Actually, any device which gives
high-to-low or low-to-high level changes can be used to move the motor. If it is your first time
installation, it is recommended to disconnect the motor shaft from the load in case of accident. You
can start from low pulse frequency then going to high. One triggered edge of the pulse makes the
motor move one micro angle. There is no minimum speed limit for ES servo however the maximum
running speed will be determined by the input voltage and current setting.
www.servosystem.ru +7(495) 407-01-02