Leader Electronics Corp. LT 443D, Инструкция по эксплуатации

Страница: 220 / 239

CS-22
4.11 Setting V. DRIVE TIMING
4.11.1 Setting TIMING
This section describes setting procedure of the V. DRIVE signal with respect to the
internal reference signal.
Select [1. V. DRIVE TIMING], then press the [ENTER] key.
(1) V-PHASE (V: Vertical)
This mode is used to set the vertical timing.
The timing can be set in one line steps by pressing the Up or Down key.
Press the [ENTER] key to enter data. The menu returns to hierarchy level 1 [1. V.
DRIVE TIMING].
Pressing the [MENU] key selects the next higher hierarchy.
In case of +5 LINE is set.
Hierarchy level 3
3. V-PHASE R: 2.997 Hz
CS-V. DRIVE +5 LINE
4.12 Setting H. DRIVE TIMING
4.12.1 Setting TIMING
This section describes setting procedure of the H. DRIVE signal with respect to the
internal reference signal.
Select [1. H. DRIVE TIMING], then press the [ENTER] key.
Select the item to set the timing by pressing the Up or Down key, then press the [ENTER]
key.
Hierarchy level 2
2. H. DRIVE TIMING
▼
H-PHASE
▼
H-PHASE [DOT]
▲ H-PHASE [ µ s]
(1) H-PHASE [dot] (H: Horizontal)
This mode is used to set the horizontal timing in dot steps.
Press the Up or Down key to set the timing.
For NTSC, the settable range is ± 1715 dots in one dot steps.
Press the [ENTER] key to enter data. The menu returns to hierarchy level 2 [2. H.
DRIVE TIMING].
Pressing the [MENU] key selects the next higher hierarchy.
In case of +10 dot is set.
Hierarchy level 3
3. H-PHASE R: 2.997 Hz
CS-H. DRIVE +10 dot