ü
Optimum cooling is achieved by mounting the unit vertically on a flat sur-
face.
1. Fasten the unit with screws to the 4 lateral holes on the side (5 mm Ø).
ð
The unit is assembled.
8 Installation
8.1 Connecting the battery
To connect the charger to the battery, proceed as follows:
1. Disconnect the battery from the vehicle power circuit.
WARNING!
Disconnect the negative cable first.
2. Secure the positive cable of the device as close as possible to the vehicle
battery with a suitable fuse.
3. Connect the positive cable of the unit to the positive terminal of the bat-
tery.
4. Connect the negative cable of the unit to the negative terminal of the bat-
tery.
5. Connect the vehicle battery to the vehicle power circuit again.
ð
The battery is connected.
8.2 Connecting the unit to the 230 V mains
Fig. 5:
Neutrik plug
connection
To connect the unit to the 230 V mains, proceed as fol-
lows:
1. Fit the Neutrik plug in the AC connection.
2. Turn the Neutrik plug clockwise until it clicks into
place.
NOTE!
The two-pin earthed plug is only suitable for con-
nection to fused, earthed 230 V mains supplies.
3. Plug the two-pin earthed plug into a 230-V mains sup-
ply.
ð
The charger is connected to the 230 V mains supply.
17
LEAB Automotive GmbH
Thorshammer 6
24866 Busdorf
LEAB Automotive GmbH
8 Installation
