Lea LE41140-40W, Оригинальное руководство пользователя

Страница: 11 / 58

10
operation. Let the engine cool down for about two minutes before refueling.
Refueling must not be carried out near naked flames, control lamps or spark producing
electrical equipment such as electric tools, welders or sanders.
1. Make sure the machine is turned off, by turn the engine switch to the “off” position.
2. Check the fuel by a visual check , remove the fuel cap and reviewing the fuel level.
3. Full unleaded fuel from an approved fuel container into the fuel tank, because of fuel
expands, please fill the tank to the neck of tank only.
4. Turn the fuel cap clockwise to assembly it in position.
WARNING.
•
Do not refill fuel while engine is running or hot.
•
Make sure fuel is not leaking from the rear outlet tube of fuel drain hole.
Use at least 90 octane fuel. We recommend unleaded petrol as it leaves fewer residues
inside the motor and on the ignition plug, and prolongs the life cycle of the exhaust system.
Never use old or dirty petrol or oil/petrol mixtures. Avoid contamination with dirt or water in
the tank. Occasionally ignition knocking or clanging can be heard with high loads. This is
normal and no cause for alarm. If ignition knocking or clanging occurs during normal loads
and with constant motor speed you should change the petrol quality. If this does not solve
the problem contact an authorized specialist dealer.
When working at continuous high revs a higher octane rating is recommended.
Check the air cleaner
Check the air filter to be sure it is clean and in good condition.
Remove the air cleaner cover, then check the main air filter. Clean or replace the air filter
if necessary.
Accelerator lever adjustment
Adjust the accelerator lever in appropriate position to adjust the running speed of engine. (Fig.
10)
Fig. 10
START THE ENGINE
1. Move accelerator lever to “CHOCK” position. (Fig. 11)
2. Grasp starter handle and pull out slowly. Until it pulls slightly harder.(Fig. 12)