26
USAGE
Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside using warm water with a
low concentration of dishwashing liquid. Do not use abrasives or scouring powder; they may scratch the
surface finish.
USAGE
CAUTION! Wine cabinets are intended only for storing and preserving wine.
IMPORTANT: Your wine cabinet is ideally suitable for holding Bordeaux type bottles of 0.75 L capacity. It
can contain larger bottles; however care must be taken that they do not prevent the door from closing
properly.
-
When closing the door ensure that it does not touch any of the bottles.
-
If you load several bottles at a time, it will take longer before the cabinet reaches the desired
temperature.
-
In order to avoid damaging the door seal, ensure that the door is fully open before moving the
racks along the compartment rails.
Adjusting the temperature
Control Panel
1
2
3
4
5
6
7
8
1 - On / Off button
2 - Zone selection button
3 - T ° unit selection button
4 - Upper Zone temperature display
and light adjustment
5 - Lower Zone temperature display
6 - Button to increase the temperature
7 - Button to decrease the temperature
8 - Light adjustment knob
1. ON / OFF switch: Press twice to turn the unit on or off.
To switch off the unit, press the button once, the display will show OFF, press again, the unit will turn off.
When the machine is off, press the ON / OFF switch on, the display panel indicates ON, press again, the
unit will turn on.
When the machine is off, all lights are off and all other buttons are off. All temperatures and other
settings will remain the same the next time the machine is turned on.
2. Zone select button, each press selects the zone where the temperature should be set. The selected
zone flashes (display 4 or 5). Then choose the temperature using the 6 and 7 keys. Without action, after
a few seconds, the action is deactivated.
3. Button to change the temperature unit; degrees Celsius ° C / Fahrenheit ° F
4-5. Displays: indicate the temperature present in each zone and the set temperature during the setting.
The display 4 also indicates the color of the light.
6. Temperature s, allows to increase the temperature by 1 degree,
