23
SETTING UP THE CABINET
If this device, which uses magnetic door closing, replaces a device equipped with a spring closing
system, we advise you to destroy the spring closing system before disposing of the old device. This will
prevent children from locking themselves inside it and endangering their lives.
Location
Place your cabinet well away from heat sources (heater, cooker, direct sunlight). For proper operation of
the device, the ambient room temperature should be b10°C and +32°C (class SN-N). Outside
these limits, the device will not operate properly.
– Ensure that air can circulate freely behind the device: do not place it too close to a wall, in order to
avoid noise from vibration. Ensure that air can circulate freely all around the device. Insufficient
ventilation will lead to poor operation and increased energy consumption.
Leave at least 2 cm between the walls and the wine cabinet and 3 cm minimum between the rear of the
wine cabinet and the wall. Leave at least 10 cm free space above the device.
– The device must be installed in such a way that the electric plug is accessible. After installing
the cabinet, make sure that it is not resting on the power cord.
– Level the device by using the 2 adjustable feet.
Recessed mounting
This device can be freestanding or built-in under a work surface. In the latter case, the size of the device
must be taken into account:
Width
595 mm
Depth
570 mm
Height
870-890 mm
Connecting the power supply
Your cabinet is designed for operation with 230 V single-phase.
It must be connected to a wall socket equipped with earthing and protected by a 10 A fuse in
compliance with the local standard and in compliance with your electricity supplier's
prescriptions.
Important Note:
During installation of the handle on the glass door, it is mandatory to use the specific gaskets
supplied and screw without forcing.
Failure to comply with these requirements may result in breakage of the glass and will not be
supported by the manufacturer's warranty.
