Astro 250 HP 3200K and 5600K, DMX 512+ RDM LED followspot - User’s Manual – 1.0
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
– web www.ldr.it
5
Ensure the plug conforms to the relevant EU/UL or local electrical standards
To perform a correct wiring, please note that the cores in this mains lead are colour-coded as
follows:
Ground: green+yellow – Neutral: blue - Phase: brown
In case the colours of the wires do not correspond to the colour of the connection points on your
plug, please proceed as follows:
•
The green or green and yellow wire must be connected to the connection point marked with
the letter E or with the symbol or coloured in green or in green-yellow
•
The blue wire must be connected to the connection point marked with the letter N or
coloured in black
•
The brown wire must be connected to the connection point marked with the letter L or
coloured in red
Before you finally position this product for use, temporarily connect it to a properly fused power
supply to check the unit works correctly.
9. VOLTAGE
Before operating this unit please refer to the product label mounted at the back of the luminaire to
check you are operating with the correct voltage. The Astro 250 LED can be operated between 100V
and 260 VAC.
10. LOCAL CONTROL PANEL AND OPERATION
OPERATION: LCD display for DMX address, system setup and status details.
POWER: power LED status indicator , red color. ON= power
DMX: DMX LED status indicator, green color. LED OFF = DMX OFF and manual control activated ,
LED ON = DMX MODE activated with no DMX signal, FLASHING LED = receiving DMX
MENU: rotary switch selector to select and modify the operational modes. Turn left or right to
navigate through the menu and press to select or to confirm
DMX IN: input DMX signal (pin1=0 , pin2= DATA- , pin3=DATA+ ).
DMX OUT : Loop through DMX signal output
POWER IN: Mains power input
POWER OUT: Mains power output
11. MENU
There are fourteen different menus to control the settings of the ASTRO LED. The rotary selector is
used to adjust the settings and to navigate through the menu. Turn left or right to select the menu
and push to access or to confirm the selected data or functions. To exit the selected menus without
saving the data, press the rotary selector for at least 1 second.
