Astro 250 HP 3200K and 5600K, DMX 512+ RDM LED followspot - User’s Manual – 1.0
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
– web www.ldr.it
4
•
Insert a Phillips screws driver at least 12cm long in each one of the holes provided at the
front of the colour changer and tighten each screw
•
Ensure the colour changer unit is secure, and all three screws are tight.
5. MOUNTING THE IRIS DIAPHRAGM - supplied
The iris diaphragm supplied with the followspot has 20 leaves to size the beam from a maximum
aperture of 68mm to a minimum of 5mm. A black-out iris diaphragm is available to special order.
•
Using a Phillips screw-driver remove the two cross-head screws from the sides of the iris
plate.
•
Slide the diaphragm in the gate area.
•
Fix the iris in position by tightening the previously removed screws
Important notice: do not leave the iris closed for over 5 minutes while the LED is on
FAILURE TO COMPLY WITH THE ABOVE NOTICE MAY CAUSE THE IRIS AND THE FOLLOWSPOT TO
SUFFER MAJOR HEAT DAMAGES AND WILL INVALIDATE THE PRODUCT WARRANTY
6. SHUTTER BLADES (accessory, part nr. R80208019 x 4)
Shutter blades are not supplied with the unit but are available as separate accessory. They are sold
as single items and relevant part number is R80208019, 4 are required.
7. ADJUSTING THE YOKE
This followspot is provided with a yoke balancing adjustment. The balancing point is factory set for
the standard product configuration supplied (without colour changer for standard units, with colour
changer for the kit version). However, should you need to adjust the balancing, please follow the
procedure here below:
•
The followspot must be mounted on the tripod stand with all relevant accessories attached.
•
Using a Phillips screw driver, loosen the 2 M5 screws on each side of the yoke.
•
Gently slide the followspot backwards or forwards to the required position.
•
Make sure the yoke is correctly aligned horizontally.
•
Tighten the 4 M5 screws
8. WIRING
Before being connected to the mains power, this unit may need to be wired with a suitable plug if
not already installed. Make sure the plug you are using is rated for the proper power load.
This fixture must be grounded
