LDARC TINY R7, Инструкция по эксплуатации

Страница: 6 / 9

LDARC TINY R7 Instruction Manual 2018-03-05 9 Pages-Page 6
Receiver status LED will blink twice then solid when power on, the meaning as follow.
First blink 【receive mode】 Second blink 【failsafe mode】 Then solid 【signal status】
■ FUTABA S-FHSS ■
Failsafe mode 1
■
No signal
■ FRSKY D16 ■
Failsafe mode 2
■
Signal received
BIND: check receive mode before bind, the first blink after power on indicate the
setting
■ is S-FHSS， ■ is D16。
FUTABA S-FHSS BIND FRSKY D16
（NO Telemetry） BIND
Turn on the TX then power on receiver
while pressing the key, green LED fast
blink meaning already in bind mode,
user can release the key. Bind procedure
is completed and the receiver is working
normally when green LED is solid.
Power on receiver while pressing the key,
green LED fast blink meaning already in
bind mode, user can release the key, then
set your TX into D16 bind mode. red LED
solid meaning bind finished, exit TX from
bind mode, receiver’s green LED solid
meaning working normally.
FAILSAFE: second blink after power on indicate failsafe setting, please make sure
failsafe is working correctly !
After 1 second when lost transmitter
signal, S.BUS keep output, Throttle will
988us, all other channels will 1500us.
After 1 second when lost transmitter
signal, S.BUS not output, user should
setting related parameters to ensure
flight controller handle failsafe.
■
FAILSAFE MODE 1
■
FAILSAFE MODE 2
FAILSAFE MODE AND RECEIVE MODE SWITCH:
Press the key and hold when receiver working
normally, the LED will go off, after 3 seconds
yellow LED will blink once, release the key
receiver will switch to another failsafe mode
then restart automatic, LED will blink twice
then solid, for definitions of LED please
reference STATUS LED define above.
Press the key and hold when receiver working
normally, the LED will go off, after 3 seconds
yellow LED will blink once, keep hold until
yellow LED solid, release the key receiver will
switch to another receive mode then restart
automatic, LED will blink twice then solid, for
definitions of LED please reference STATUS LED
define above.
FAILSAFE MODE SWITCH RECEIVE MODE SWITCH
F3-B2RX FC(
Dual-mode
S-FHSS+D16
receiver inside FC
)
Onboard dual-mode receiver use S.BUS connect to FC's UART2 port,default S-FHSS.
LED
4V
GND
-
+
Antenna
Receiver key
Receiver status LED
BOOT
please use plastic
tool to click the key
1S BATTERY
LED
VTX