LCT 208cc SERIES, Руководство по обслуживанию

Страница: 11 / 25

Rev:072409 Copyright © 2009 Liquid Combustion Technology, LLC LCT Engine Service Manual: 208cc, 291cc & 414cc 10
Engine Oil Level Check
Check the engine oil level with the engine stopped and with the engine in a level position.
1. Remove either side mounted filler cap dipstick or high oil fill dipstick and wipe it clean.
2. Insert and remove the dipstick without screwing it into the filler neck. Check the oil level shown on the dipstick.
3. If the oil level is low, fill to the edge of the oil filler hole with the recommended oil.
4. Securely screw in the filler cap/dipstick. Running the engine with a low oil level can cause engine damage.
Always check the engine oil before start up.
Engine Oil Change
Drain the used oil while the engine is warm. Warm oil drains quickly and completely.
Avoid contact with hot oil.
1. Place a suitable container below the engine to catch the used oil then remove the
filler cap/dipstick and the drain plug.
2. Allow the used oil to drain completely, then reinstall the drain plug, and tighten
it securely. Do not over tighten. Dispose of used motor oil in a manner that is
compatible with the environment. We suggest you take used oil in a sealed
container to your local recycling center or service station for reclamation. Do not
throw used oil in the trash, pour it on the ground, or pour down a drain.
3. With the engine in a level position, fill to the outer edge of the oil filler hole with the
recommended oil. (see fill limits right)
• NOTICE
Running the engine with a low oil level can cause engine damage.
4. Securely screw in the filler cap/dipstick.
Engine Oil
Recommendations
Engine oil affects performance and service life. Use 4-stroke automotive
detergent oil.
SAE 10W-30 is recommended for general use. Other viscosities shown in
the chart may be used when the average temperature in your area warrants.
The SAE oil viscosity and service classification are in the API label on the oil
container. The manufacturer recommends you use API SERVICE category
SJ engine oil, or better.
Fill if oil is
below letter
“L” on the
filler cap
Fill if oil
is below
“Add”
on the
dipstick
Max Upper
Level
Max Lower
Level