4
2
Operator Installation
2a Remove Control Box from Operator Mounting Bracket, then remove Motor/Gearbox from Bracket:
Control Box and Motor/gearbox removal
27” Pull, 27” Push, and Double Push Systems
Control Box and Motor/gearbox removal
Full Length Pull and Full Length Push Systems
2b Prepare Header/Frame and Door:
a. 27” Pull System ....................................................................................................................................................Page 6
b. Full Length Pull System .......................................................................................................................................Page 6
c. 27” Push System..................................................................................................................................................Page 7
d. Full Length Push System .....................................................................................................................................Page 7
e. Double Push System ...........................................................................................................................................Page 8
f. Low Ceiling Application ........................................................................................................................................Page 8
notE
For Push units with a reveal greater than 6” refer to the
installation sheet included in the Extended arm package.
2c Install Operator Mounting Bracket on Header/Frame. For Full Length systems, also install Switch Bracket on Header/
Frame.
2d Install Motor/Gearbox on Operator Mounting Bracket. Then install Control Box on Bracket.
2e Proceed to Chapter 3: Wiring (Page 9).
