Rev: 07.12.18
Page 6
CCD-0001607
Fig. 15
6.
Align the motor drive shaft and the top block coupler and insert the drive shaft into the coupler
(Fig. 12).
7.
Secure the tensioning spring to the catch tab on the motor (Fig. 8).
Note:
To complete the assembly, a
11/32
" nut driver is needed to secure the pins and push nuts (Fig. 13).
8.
Install the appropriate bracket on the open gear rack end.
Note:
The stepped brackets are to be used to accommodate T-molding pieces where applicable.
9.
Place the pin through both the bracket and the gear rack, securing the other end of the pin with a push
nut (Fig. 14).
Note:
The push nut should be installed from below the bracket, and the pin from above when mounted.
10.
Apply a small 1/2” square of foam to the flat edge of the gear rack located within the center of the
bracket (Fig. 15). This prevents the bracket from moving freely when installing the SlimRack® to the
slide-out box.
11.
Repeat steps 1-9 on the remaining SlimRack® column.
12.
The LCI SlimRack® System assembly is complete, and is now ready for installation onto the slide-out
box.
1/2
" Foam Square
Push Nut
Pin
Fig. 14
Fig. 13
11/32
" Nut Driver
Push Nut
Pin