LBC LMO-E-P, Инструкция по установке, эксплуатации и обслуживанию

Страница: 9 / 34

COPYRIGHT © 2020 – 2022 LBC BAKERY EQUIPMENT, INC. 9 REV 6-2022B
INSTALLATION (Part 2 of 6) .
See the Dimensions and Utility Connections section of this manual for gas connect point location.
Connec
t the gas supply line to the 3/4” NPT gas connection located at the rear of the oven. If the oven
is supplied with a flexible gas line, secure it to the oven and wall per the manufacturer ’ s specifications.
Use only connectors that comply with the Standard for Connectors for Movable Gas Appliances , ANZI
Z21.69 or Connectors for Movable Gas Appliances , CAN/CGA-6.16 with quick-disconnect devices that
comply with the Standard for Quick-Disconnect Devices for Use with Gas Fuel , ANZI Z21.41 or Quick
Disconnect Devices for Use with Gas Fuel , CAN 1-6.9.
Check the incoming gas pressure before the gas valve. Pressure must remain between 5 to 14 inch W.C.
for natural gas and 11 to 14 inch W.C. for propane gas - both with and without the burner firing.
Gas Ovens: Gas Type Conversion
1. Shut off the gas supply to the oven. Remove the bottom burner cover and the side access cover.
2. Disconnect the gas line at the top of the gas valve. Remove the four extended nuts at the bottom of
the burner assembly. Lower the burner out of the oven.
3. Remove the 15 ori fice marked “65” . Use gas-approved Teflon tape to seal the orifices.
4. Replace the burner. Reconnect the gas line and replace the covers.
5. Check for leaks.
6. Operate the burner. Adjust the gas manifold pressure to 5” W.C . Supply pressure must remain
between 11 to 14 inch W.C. for propane gas - both with and without the burner firing.
7. Apply proper labeling to indicate (
a) the
correct gas type and (b) the pressure requirements on the
data plate and at the gas connection point.
Electrical Connections
WARNING:
Gas supply connections and any pipe joint compound must
be resistant to the action of natural and propane gases.
WARNING:
This appliance, when installed, must be electrically
grounded in accordance with local codes, or in the
absence of local codes, with National Electrical Code,
ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.2 ,
as applicable.
WARNING:
Gas Ovens: Do not connect oven to electrical supply
until after gas connections have been made.