Setting the Pulse / Tone
switch.
Before you can dial a call on the
Summit conference phone, you
must select which form of dialling
it will use.
All domestic telephone lines in
the U.K. now accept Tone
dialling. This is both fast and
accurate and should be selected
if possible.
When connected as an extension
of an office telephone system
(PABX), the setting of this switch
will be dependant on the
telephone system in question. If
in doubt, please contact your
system supplier or following the
procedure below.
1 Set the switch to the Tone
position
2 Turn the unit ON (ON/OFF
button) and listen for dial tone.
3 Dial a known number
(remember to include any line
access digit required by the
PABX usually 9).
4 If the call is successful (ringing
or engaged tone) the switch may
be left in the Tone position. If the
call is unsuccessful, terminate
the call by pressing the ON/OFF
button. Set the switch to the
Installation
Pulse position and try the test
above again.
Using the Tone Button
If you have set the Tone / Pulse
switch to the Pulse position, you
may temporarily change to Tone
dialling by pressing the Tone
button. This may be required
when accessing automated
telephone services, which require
Tone signals.
Setting the Ringer Volume
Your Summit conference phone
will ring for incoming calls. The
Ringer Volume Switch may be
used to adjust the volume of the
ringer between High, LOW or
OFF. With the switch set to the
OFF position, the unit will not ring
for incoming calls but can still be
used to make outgoing calls, or
to answer incoming calls ringing
on a parallel extension phone
