9. .......................
10. Recall.......................................
11. / Tone ...................................
12. / Pulse ..................................
13. Dial Keys ................................
14.Speaker ........... .......................
15. Wall Mounting Clip ........
16. Hookswitch .............................
17. Handset Park ......... ..............
1
8. Recall Selector Switch ............
19. Message Wait Selector
Switch .....................................
.
In the Idle mode, press and hold to adjust the ringer
volume.
In Speakerphone or Headset mode, press to adjust
the receive volume.
While using the handset, press to adjust the
handset volume.
Activate a Recall Signal (Timed Break ‘F’ or Earth
‘E’ according to the setting of the switch at the rear
of the phone)
Press and hold for 10 seconds to change from
Pulse to Tone dialling.
In Pulse mode, short press for a temporary switch
to Tone dialling.
Press and hold for 10 seconds to change from
Tone to Pulse dialling.
Dialling keys for calling numbers and entering
names in Direct Memories.
Loudspeaker
Wall mounting handset clip - pull out and turn
through 180 degrees, then replace. The handset
will hang on this clip when the phone is wall
mounted.
Press to disconnect a call.
Rest the handset on this clip when the phone is wall
mounted and you wish to hang up the handset
without disconnecting the call.
Use to select Timed Recall (F) or Earth Recall (E).
Use to select the type of Message Wait Signal sent
by the PABX (office PABX use only).
18 19
ii
6
Phone Settings (continued)
Changing from Tone to Pulse Dialling
When supplied, the phone is set for Tone Dialling. This is the most common form of dialling and works on all
domestic telephone lines in the UK.
If the phone is connected to an extension of an office telephone system (PABX) that only supports Pulse
dialling, then the following method may be used to change from Tone to Pulse.
With the phone On-Line (handset up)
Press and hold the # (PULSE) button.
After 10 seconds you will hear a beep tone to confirm the change.
Hang the handset up (the change will not take effect until the handset has been returned to the cradle).
Temporary Change to Tone
When in the Pulse mode, it may be necessary to generate M.F tones (to activate automated services etc).
To make this change
Press the (TONE)
button.
Changing from Pulse Dialling to Tone Dialling
With the phone On-Line (handset up)
Enter any digit
(This will clear dial tone so yo can hear the confirmation beep)
Press and hold the (TONE) button for 10 seconds.
Hang the handset up (the change will not take effect until the handset has been returned to the cradle).
#
