15
14
La-Z-Time
®
Power Motion-Modulars
®
Assembly Instructions
Motion-Modular units with metal base rails have one locking latch bracket and one latch bracket
on the right side (sitting) of modular units without right side arms, and two stud mounts with
threaded studs on the left side (sitting) of modular units without left side arms (F
IGURE
11).
Motion-Modular units with wood legs have one side mount locking latch bracket and one side
mount latch bracket on the right side (sitting) of modular units without right side arms, and two
threaded studs on the left side (sitting) of modular units without left side arms (F
IGURE
12).
13. Use a T-30 torx driver to loosen the threaded studs to approximately 1", this measurement may
vary depending on the fabric and style (F
IGURE
13). The threaded studs are located on the left
side (sitting) of modular units without left side arms.
14. Align the units to be joined next to each other. Move the unit with the latch brackets approximately
4" forward of the unit with the threaded studs. The latch brackets are located on the right side
(sitting) of modular units without right side arms.
15. Slide the unit with the latch brackets back until the threaded studs are securely engaged in both
the front and rear latch brackets. The rear bracket is not a locking bracket.
Note: Due to variations in upholstery and style, the threaded stud length may need to be adjusted
to fit into the latch brackets. Loosen or tighten the threaded studs to provide adequate clearance.
16. Continue connecting the modular units until all have been securely joined.
17. Proceed to the
Battery Backup Assembly Instructions
.
La-Z-Time
®
Power Motion-Modulars
®
Assembly Instructions
F
IGURE
11
F
IGURE
12
F
IGURE
13
F
IGURE
14
NOTICE:
To reduce the risk of product damage –
•
Do not move the units while latched together. The purpose of the latch bracket system
is to connect the units and prevent them from being separated. The latch bracket system
does not provide adequate structural support for the movement of connected units.
18. All modular units must be disconnected to safely move the modular group. To disconnect the
units, apply pressure to the swing arm of the locking latch bracket (F
IGURE
14) and slide the unit
forward. Repeat this step to disconnect the remaining units.
Latch Bracket
Locking Latch
Bracket
Stud
Mount
Threaded
Stud
Threaded
Stud
Side
Mount
Latch
Bracket
Side Mount Locking
Latch Bracket
Threaded Stud
Stud
Mount
Base Units
Leg Units
Base Units
Leg Units
Locking
Latch Bracket
Side Mount Locking
Latch Bracket
