3.2.5. Press the same desired device mode key again as
in step 2 above. (e.g. TV)
3.2.6. Hold down "
" and "
VOLUME-
"
together simultaneously again for 2 seconds until
the upper 4 red device mode indicators light up
(TV, DVD, SAT, VCR) The lower clear function
keys will also be lit and you will hear 2 beep tones.
3.2.7. Aim the LR at your device (e.g. TV); press the " "
(power) key repeatedly every 1-2 seconds until the
device has been turned off. The red LED indicator
will blink once each time you press the " " (power)
key to indicate your remote is scrolling thru the
code library. Once your device has been turned off,
immediately press the same device mode key (e.g.
TV) to lock in the search code and the red upper 4
red device mode indicators will flash 3 times and
your programmed device mode key should remain
lit.
* Simply repeat the above setup procedures to search
the Device Code for your VCR, SAT, DVD and other
Devices. (Remember to press a correct Device Mode
Key and correct Search Code in step 3 . 2 . 2 - 3 . 2 . 7
above).
* For set up of Auxiliary devices (AUX 1-8) press
"
SHIFT
" followed by the desired device key (AUX
1-8) then follow steps 3.2.3-3.2.7 above.
Note:
-
When programming AUX 1-8 devices the device
key backlight will be green.
-
The search process can take several minutes due to
the number of codes stored in the library.
-
You cannot search through the code library for
DVR devices. This code must be entered from the
LR infra red device code list.
15
Important:
During set up mode, the upper 4 red device mode
indicators will blink six times and the set up procedure
will be terminated if any of the following conditions
occur;
-
No key has been pressed for more than 8 seconds.
-
An invalid code number has been entered.
-
An invalid key (not a numeric key) has been pressed.
You can press
SMART 1
,
SMART 2
or
SMART 3
to
exit the search mode at any time. The upper 4 red device
mode indicators will flash 6 times to indicate your remote
has exited the search procedure.
Important:
When searching through the Library for some older
devices, if the power on/off function of your device is
not infra-red controlled - you need to follow steps 3.2.2
to 3.2.6 above and start searching:
-
Press " " (power) key and another important
function key alternately until your device responds to
the expected function, press the same device mode
key (e.g. TV) to lock in the code.
-
Press " " (power) key & "
" alternately, or;
-
Press " " (power) key & "
1
" alternately.
Note:
- Each time you press the " " (power) key, the LR
will skip to the next code and send out a POWER
signal trying to turn off your device.
-
If you failed to stop pressing the " " (power) key in
time when your device has been turned off, turn on
your device again immediately. Before the 4 red
upper device mode indicators goes out, press " "
(mute) on the LR to skip backward. Repeat the step 7
above and lock in the code.
-
If the 4 upper device mode indicators flash 6 times
after you pressed the " " (power) key, you are
already at the last code of the library.
- Besides device keys, " " (power) key and " "
(mute) key, all keys can be operated if the remote has
entered search mode.
16
