![LawnMaster GLADIATOR PRO Скачать руководство пользователя страница 16](http://html1.mh-extra.com/html/lawnmaster/gladiator-pro/gladiator-pro_safety-and-operating-manual_3991773016.webp)
A STEELFORT PRODUCT
16
Does not start
Clean / replace air filter
Fill fuel tank
Drain tank and refill with fresh clean fuel
PROBLEM
CAUSE
SOLUTION
Hard to push
Loss of power
Dirty Air Filter
Out of fuel
Stale fuel
Water in fuel
Drain fuel tank and carburetor
and refill tank with fresh fuel
Spark plug wire is disconnected
Connect wire to plug
Bad spark plug
Replace spark plug
Loose blade or broken blade adapter
Control bar in defective
Engine flywheel brake is on when
control bar is released
Bent engine crankshaft
Cutting height too low
Rear of lawnmower housing/
blade dragging in grass
Blade adapter broken
Lift on blade worn off
Grass catcher too full
Blade dragging in grass
Grass is too high or wheel height is
too low
Raise cutting height
Raise rear of lawnmower housing 1
setting higher
Empty grass catcher
Adjust handle height to suit
Set to ‘Higher Cut’ position
Set to ‘Higher Cut’ position
Clean / replace air filter
Clean underside of mower
Check oil level
Cut at slower walking pace
Catcher not venting air
Handle height position not right for you
Rear of lawnmower housing of cutting
blade dragging in heavy grass.
Cutting too much grass
Dirty air filter
Buildup of grass & leaves under mower
Too much oil in engine
Walking speed too fast
Contact your LawnMaster dealer
Raise cutting height
Replace blade adapter
Replace blade
Move lawnmower to cut grass or to hard
surface
Clean grass catcher
Depress control bar to upper handle before
pulling starter rope
Control bar defective
Replace control bar
Depress control bar to handle
Tighten blade bolt or replace blade
adapter
Starter rope hard
to pull
Grass catcher not
filling (if required)
TROUBLESHOOTING
Содержание GLADIATOR PRO
Страница 1: ...PROUDLY NZ OWNED A STEELFORT PRODUCT ...