30
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Mower fails to operate.
Possible clogging.
Check underneath the mower and
clear as necessary (always wear
gardening gloves).
The battery is not fully charged. Charge the battery.
The battery is not inserted
(properly).
Ensure the battery is correctly inserted.
The grass is too long.
Increase the height of cut and tilt
garden product to reduce the starting
load.
The battery is too hot/cold.
Allow the battery to cool/warm to room
temperature.
The isolator key is not inserted
correctly/fully.
Fit the key correctly.
There is a short delay in the
motor starting after engaging
the switch lever.
This is normal. Hold the switch lever
for 1-3 secs to start the motor.
Motor starts and stops
Immediately.
The battery is not fully charged. Charge the battery.
The isolator key is not inserted
correctly/fully.
Fit the key correctly.
The battery is not inserted
(properly).
Ensure the battery is correctly inserted.
The battery is too hot/cold.
Allow the battery to cool/warm to room
temperature.
Garden product functions
intermittently.
Motor protector has activated.
Allow the motor to cool and increase
the height of cut.
Lawnmower leaves
ragged cut.
Height of cut is too low.
Increase the height of cut.
Cutting blade is blunt.
Replace the blade.
Only perform the steps described within these instructions! All further inspection, maintenance and
Gloves and appropriate protective clothing must be worn when performing these instructions.
Always turn off the machine and remove the battery pack and isolator key before making any
adjustment.
WARNING
