LawnMaster CLGT4012K, Руководство оператора

Страница: 12 / 20

12
OPERATION
Intended Use
This cordless grass trimmer is designated with rated voltage of 36V D.C. . It is designed only to be
used with battery packs 40LB4001. The fixed line trimmer head installed on this product is intended
to cut smaller types of weed, lawn grass or similar soft vegetation in areas that are hard to reach,
e.g. under bushes, on slopes and edges. It may not be used to work on unusual thick, dry or wet
grass, e.g. pasture grass, or to shred leaves. For safety reasons it is essential to read the entire
instruction manual before first operation and to observe all the instructions therein. This product is
intended for private domestic use only, not for any commercial trade use. It must not be used for
any purposes other than those described.
ON / OFF Switch
1. Press the lock-off button on either side and hold it in position (Fig. 9, STEP 1).
2. Press the on/off switch to switch the product on (Fig. 9, STEP 2). The lock-off button can then
be released.
3. Release the on/off switch to switch the product off.
Safety Guard
Safety guard protects the operator against thrown objects during operation. The safety guard is
equipped with a line cutting knife that cuts excess trimming line (Fig. 10).
General Operation
• Check the product, its battery pack and charger as well as accessories for damage before each
use. Do not use the product if it is damaged or shows wear.
• Double check that accessories or cutting device are properly fixed.
• Always hold the product by its handles. Keep the handles dry and free from lubricant to ensure
safe support.
• Ensure that the air vents are always unobstructed and clear. Clean them if necessary with a soft
brush. Blocked air vents may lead to overheating and damage the product.
• Switch the product off immediately if you are disturbed while working by other people entering the
working area. Always let the product come to complete stop before putting it down.
• Do not overwork yourself. Take regular breaks to ensure you can concentrate on the work and
have full control over the product.
Fig. 9 Fig. 10
STEP 2
STEP 1
3
4
9
15