LawnMaster CLBC4009K, Руководство оператора, Страница: 7 / 26

7
GENERAL SAFETY RULES
• Inspect and maintain the product regularly. Have the product repaired only by
an authorized service center or similar qualified specialist.
• When not in use, store the product out of the reach of children.
Brush Cutter Blade Safety Warnings
• Only use brush cutter blades if you have knowledge of how to use and handle them.
• Pay attention to the maximum rotational speed. The maximum rotational speed
marked on the brush cutter blade shall not be exceeded. Where stated, the
speed range shall be adhered to.
• Do not use working brush cutter blades which are cracked. Scrap of brush
cutter blades which bodies are cracked. Repairing is not permitted.
• Clamping surfaces shall be cleaned to remove dirt, grease, oil and water.
• Do not use loose rings or sleeves to «make up» bore sizes on brush cutter blades.
• Pay attention that fixed rings for securing the brush cutter blades have the
same diameter and at least 1/3 of the cutting diameter.
• Ensure fixed rings are parallel to each other.
• Handle brush cutter blades with care. Store them in the original packaging or
in special boxes. Wear gloves for handling and to reduce injuries.
• Ensure all guards are correctly fixed before using brush cutter blades.
• Before use, make sure that the brush cutter blade complies with technical
requirements of the power tool and correctly fixed.
• Use the supplied brush cutter blade only for cutting of wood, never for metal.
• Blade thrust may occur when the spinning blade contacts an object that it does
not immediately cut.
• A blade thrust can be violent enough to cause the unit and/or operator to be
propelled in any direction, and possibly lose control of the unit.
• Blade thrust can occur without warning if the blade snags, stalls or binds.
• Blade thrust is more likely to occur in areas where it is difficult to see the
material being cut.
Vibration And Noise Reduction
• To reduce the impact of noise and vibration emission, limit the time of operation,
use low-vibration and low-noise operating modes as well as wear personal
protective equipment.
• Take the following points into account to minimize the vibration and noise
exposure risks: