Figure 44
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
Charging the Battery
Refer to Charge the Battery in the Setup section.
Replacing the Fuse
If the battery does not charge or the engine does not turn
with the electric starter, the fuse may be blown. Replace it
with a 40-amp plug-in type fuse. Refer to Install the Fuse
in the Setup section.
Lubricating the Wheel Gears
1. Remove the wheel bolt in the center of each
rear
wheel
and remove the rear wheels.
2. Apply a lubricating oil to the inner and outer sides of
the gear as shown in Figure 45.
Figure 45
3. Install the front wheels.
Lubricating the Upper Handle
Lubricate the left and right sides of the upper handle with a
low-viscosity silicone spray lubricant yearly or as needed.
1. Spray the outer plastic end of the inner handle (Figure
46).
Figure 46
Note:
Use the straw that comes with the spray can to
direct the spray.
2. Push the upper handle fully down and spray the inner
plastic surface of the outer handle (Figure 47).
Figure 47
17
