Lawn-Boy 10730, Руководство оператора, Страница: 10 / 20

Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.
Using the Self-propel Drive
(Self-propel models only)
To operate the self-propel drive, squeeze the self-propel drive
bar (Figure 14) toward the handle and hold it.
Figure 14
1. Self-propel drive bar
To disengage the self-propel drive, release the self-propel
drive bar.
Note:
The maximum self-propel ground speed is fixed. To
reduce the ground speed, increase the space between the
self-propel drive bar and the handle.
Stopping the Engine
Service Interval: Before each use or daily
To stop the engine, release the blade-control bar (Figure 15).
Note:
Remove the ignition key when you leave the machine
(electric-start models only).
Important:
When you release the blade-control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.
Figure 15
Mulching the Clippings
Your machine comes from the factory ready to mulch the
grass and leaf clippings back into the lawn.
If the grass bag is on the machine, remove it before mulching
the clippings. Refer to Removing the Grass Bag (page 11).
Bagging the Clippings
Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
WARNING
A worn grass bag could allow small stones and other
similar debris to be thrown at you or in the direction
of bystanders, resulting in serious personal injury
or death to you or to bystanders.
Check the grass bag frequently. If it is damaged,
install a new Lawn-Boy replacement bag.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
1. Lift up the rear deflector (Figure 16).
1
2
G024075
3
4
Figure 16
1. Rear deflector 3. Rod end (2)
2. Notch in the handle
bracket (2) 4. Grass bag
2. Insert the rod ends of the grass bag into the notches
in the handle brackets (Figure 16).
3. Allow the rear deflector to rest on the bag.
10