Lavinia Boho Biore, Инструкции по монтажу и использованию

Страница: 6 / 10

3. Install the assembled legs on the bathtub depending on its dimensions.
4. Fix the profiles with the self-tapping screws (4). Turn the bathtub over.
5. Install the drain and overflow, prior having removed part of protective film of the bathtub (4).
6. Install the bathtub in the required place. Check the level of the bathtub horizontal position relative to
the floor with the gauge and adjust the position of legs.
7. Draw line on the wall along the upper edge of the bathtub sides. Move the bathtub aside.
8. Mark the openings (4 openings) to install the clamping brackets (6) (3 brackets on the long side and 1
on the short side).
9. Drill Ø 8 mm openings.
10. Batter in the anchors into the openings and screw in the clamping brackets (4 brackets)
with the self-tapping screws.
11. Connect the drain and overflow to the sewage system.
12. Lift the bath, insert the vertical sides to the brackets screwed to the wall.
13. Adjust the position of legs so that the bathtub turns into strictly horizontal position. Fix the legs with
locking nuts.
14. Fill the bathtub with water and apply sanitary sealant (silicone) on the bathtub surface
adjacent to wall, prior having removed part of protective film.
15. The product should not be used 24 hours for the sealant to harden.
16. After sealant hardens completely, drain the water and remove the protective film from bathtub.
INSTRUCTIONS FOR INSTALLING THE SET OF FRAME WITH MOUNTING KIT
Specifications
No.
Item
Qty., pcs.
1 Steel frame
1
2 M12x550 mm Stud 4
3 M12x150 mm Stud 2
4 M12 Nut
22
5 Top plastic support 4
6 4.8*12 Tapping screw
8
7 Clamping brackets (included) 4
8 Adjustable supports
6
6 Lavinia Boho