Superabrasive
Owner’s Manual Original Language – Lavina
®
32-S-E
6/2013
8
LEADING POWER CABLE
There is the possibility to lead the power cable through a shackle mounted on
the hoisting ring.(see fig. 3.19).
STORAGE
Always store and transport the Lavina
®
32-S-E in a dry place. Never transport
the Lavina
®
32-S-E unprotected; it may be damaged if transported unprotected
during rain or snow.
When during the storage of the machine the temperature
may fall down to or less 32F (or 0
o
C) you should empty the
water from the system using following steps:
‐
Pull out the hose of the tank (Fig.3.20)
‐
Using compressed air blow out the water from the system for the two positions of the turn-cock (Fig. 3.21, Fig.
3.22
).
THIRD WHEEL
With Lavina
®
32-S-E there is a
possibility for mounting of a 3rd
wheel support complete assembly
(Fig.3.23), which ensures easier
handling Mounting/Dismounting with
Pin assembly (see Fig. 3.24 1-2).
While working there is a possibility to
turn the wheel support 90º(Fig.3.24).
Pull out the handle,turn it in 90°and
fix again.
4. OPERATION
PRELIMINARY CONTROLS
Inspect the working area as explained in the safety instructions. For wet use, fill in the water tank when the electrical
cable is disconnected. Connect the vacuum extractor and ensure that the vacuum hose is clear and it will follow the
machine easily. Plug in the machine and make sure that the power cord is free to follow the working direction of the
Lavina
®
32-S-E.
CONTROL OF THE WATERFLOW
The operator can choose the water sprays with valve (Fig.4.2
1)in the front (fig.4.1) when the level of the tap is in the
vertical
position , when the level is in the horizontal position
water will spray under cover of the machine.
The valve (Fig. 4.2 2) is controlling the flow of
an external water supply. A ¾” water tube can be attached to
the quick connection (Fig. 4.2 3).
ADJUSTING AND MOUNTING TOOLS
Mount the tools only after ensuring that there is nough diamond
bond material left. Be sure that the plates are always clean
before mounting. WARNING: Secure always the“Quickchange”
pads with the security plate (Fig.4.3), lock with the tool holder
key (Fig.5.3). Diamond tools with Velcro are attached on six
foam plates of 9 inch(Fig.4.4). The foam plates are mounted on
the key lock (butterfly).Always use the tool holder key (Fig.5.3).
Figure 4.4
Figure 4.3
Figure 4.1
Figure 4.2
Figure 3.24
Figure 3.23
Figure 3.19
Figure 3.20
Figure 3.22
Figure 3.21
