background image

27810 Avenue Hopkins, Valencia, CA 91355   •   www.lavi.com   •   800.624.6225

Part No. 87-230

Page 1

Installation Instructions

Queue Guard

 Germ Shields

STEP

1

1

STEP

To ensure the public’s safety, please follow the best practices outlined below when configuring the layout of a Queue 
Guard™ barrier system.

for 78-inch-tall system using 80-inch-tall Beltrac

®

 stanchions

Parts List:

A.  Beltrac 3000 80-inch Posts

B.  Queue Guard

 Protective Panel

C.  Panel Spacers

Read First: Safety Recommendations

STEP

1

2

STEP

If you received posts that were shipped knockdown, attach each base to a post. Please 
refer to Assembly Instructions shipped with each post. If you received pre-assembled 
posts or are using existing stanchions, please skip to Step 3.

Attach Post Bases

Tools Required:

F.  Allen Wrench

      

†    

To attach post base when  
shipped knockdown. Included  
with all knockdown posts.

•       Use Beltrac 3000 Heavy Base Posts for every  

start and end post

•     Use Beltrac 3000 Heavy Base Posts for every  

4th post

•     Incorporating 90-degree turns will increase the 

stability of the system

•     Do not remove the “Do Not Lean” safety labels  

affixed to each panel

A

B

C

* Posts sold separately.

Installation Instructions

27810 Avenue Hopkins, Valencia, CA 91355   •   www.lavi.com   •   800.624.6225

Part No. 8X-XXXX

 

Lower the post tube onto the base insert. 

 

The bottom rim of the post tube should be flat and  
flush against base. 

or

 

Tilt post on its side while maintaining flush fit between post and base.

 

On bottom of the base: Use supplied Allen wrench (5/16 drive) to 
tighten the center hex bolt until fully secured. 

A SECURE CONNECTION IS IMPERATIVE:

 Torque until the bolt 

is tight and cannot be turned by hand any further. 

 

Check placement of post on the base and re-tighten hex bolt if 
necessary. Stand post upright and position post for use.

STEP

1

1

STEP

Beltrac

®

 Post

Rubber or Metal Base Insert

Parts:

A.  Post

B.   Beltrac

®

 Rubber Base Insert  

or Beltrac

®

 Metal Base Insert

C.  Allen Wrench

A

B

C

Attach Post to Base

STEP

1

2

STEP

Secure the Connection

Rubber Base Insert

Metal Base Insert

Отзывы: