27810 Avenue Hopkins, Valencia, CA 91355 • www.lavi.com • 800.624.6225
Part No. 87-230
Page 1
Installation Instructions
Queue Guard
™
Germ Shields
STEP
1
1
STEP
To ensure the public’s safety, please follow the best practices outlined below when configuring the layout of a Queue
Guard™ barrier system.
for 78-inch-tall system using 80-inch-tall Beltrac
®
stanchions
Parts List:
A. Beltrac 3000 80-inch Posts
B. Queue Guard
™
Protective Panel
C. Panel Spacers
Read First: Safety Recommendations
STEP
1
2
STEP
If you received posts that were shipped knockdown, attach each base to a post. Please
refer to Assembly Instructions shipped with each post. If you received pre-assembled
posts or are using existing stanchions, please skip to Step 3.
Attach Post Bases
Tools Required:
F. Allen Wrench
†
†
To attach post base when
shipped knockdown. Included
with all knockdown posts.
• Use Beltrac 3000 Heavy Base Posts for every
start and end post
• Use Beltrac 3000 Heavy Base Posts for every
4th post
• Incorporating 90-degree turns will increase the
stability of the system
• Do not remove the “Do Not Lean” safety labels
affixed to each panel
A
B
C
* Posts sold separately.
Installation Instructions
27810 Avenue Hopkins, Valencia, CA 91355 • www.lavi.com • 800.624.6225
Part No. 8X-XXXX
Lower the post tube onto the base insert.
The bottom rim of the post tube should be flat and
flush against base.
or
Tilt post on its side while maintaining flush fit between post and base.
On bottom of the base: Use supplied Allen wrench (5/16 drive) to
tighten the center hex bolt until fully secured.
A SECURE CONNECTION IS IMPERATIVE:
Torque until the bolt
is tight and cannot be turned by hand any further.
Check placement of post on the base and re-tighten hex bolt if
necessary. Stand post upright and position post for use.
STEP
1
1
STEP
Beltrac
®
Post
Rubber or Metal Base Insert
Parts:
A. Post
B. Beltrac
®
Rubber Base Insert
or Beltrac
®
Metal Base Insert
C. Allen Wrench
A
B
C
Attach Post to Base
STEP
1
2
STEP
Secure the Connection
Rubber Base Insert
Metal Base Insert
