Installation and Setup
BLUEPOD TECHNICAL SERVICE
Tel: 1800 800 255 Email: [email protected]
Copyright Bluepod Coffee Co Pty Ltd
Page 12 of 12
LB3200 Colibri
DATE OF ISSUE: 27/01/2011
Change Giver Problem Solving
Machine not registering money on the LCD screen?
Money dropping straight through? Machine giving incorrect change?
For issues like these, please open the lower cabinet and locate the coin mechanism on the inside of the door.
It will display a green light if functioning correctly. If there is a fault, there will be an orange light that will
flash in a sequence of 1 to 4 flashes.
A sequence of 1 flash then a pause, 1 flash then a pause
- indicates a possible blockage at the top of
the coin mechanism. Remove any visible coins or foreign objects. Depress the blue reject lever and hold
down, then use thumb and forefinger to lift and swing out upper front part of coin mechanism from left to
right (cashflow 690 series sticker) and clear any coins or foreign objects. Swing panel back firmly into place.
A sequence of 2 flashes then a pause, 2 flashes then a pause
- indicates a problem with the coin dis-
criminator. Please call the Service Dept for assistance.
A sequence of 3 flashes then a pause, 3 flashes then a pause
- indicates a possible problem with coins
in the coin cassette, check visually to see if all coins are sitting flat inside the coin tubes, 50 cent pieces
sometimes do not sit flat and will not dispense properly. Remove coin cassette by using thumb and forefin-
ger to press together both left and right blue tabs, these tabs are located on either side of the white sticker
with the flashing sequences for the orange light. With blue tabs pressed together, pull out towards you the
top of the coin cassette and then lift out and up.
If there are coins that are not sitting flat then empty coin cassette and refill. Before replacing coin cassette
check the clear plastic chute that sits behind the coin cassette for any coins that may have backed up inside.
If this chute is full of coins then call the Service Dept. When all is clear, replace coin cassette by placing the
bottom of the cassette into place first then pushing the top, ensuring it clicks into place.
A sequence of 4 flashes then a pause, 4 flashes then a pause
- indicates a problem with the dispens-
ing of coins, remove the coin cassette as per previous section, remove any stuck coins. Reset the dispens-
ing arms by pressing the yellow button twice then replace the coin cassette.
By pressing the blue A, B, C, or D, buttons, coins will be dispensed from the A, B, C, D, tubes of the coin
cassette. Press each button 2 or 3 times to determine if each coin tube is dispensing correctly. If any coin
tube is not dispensing check the relevant tube for damaged or bent coins. Remove damaged coins and do
not put them back into coin mechanism!
If the LCD display shows ‘clean me’
-press the ‘yellow’ button once and then press the ‘A’ button twice
to clear this message. This message appears on the LCD display when the coin mechanism has rejected
someone’s coins too many times.
