LAUREL Electronics MAGNA RS232, Инструкция по установке и эксплуатации

Страница: 24 / 35

24
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Offset Adjustment
After you have calibrated your meter, you can use the
OFFSET OFFSET
OFFSET OFFSET OFFSET
feature to make fine addi-
tions or subtractions to the reading, without affecting the calibration itself. You must have
mode =
quan quan
quan quan
quan
(4 digits) or
quant quant
quant quant
quant
(6 digits).
For example if your weighing structure is altered after calibration and you want to subtract
the effect of 37kg of extra metalwork which was welded to the hopper, you can easily do this
by entering a value of -37 in the offset value.
Lockout Switch must be OFF
Press 3 seconds
Set1
Set2 Output
Alarms
Digit OK
Max/Min
Reset
1
2
3
4
Set1 Set2 Output Alarms
Digit OK
Max/Min
Reset
Use DIGIT button to select each digit in
turn, UP or DOWN buttons to increase or
decrease each digit’s value. If you want
to set a negative value, use DIGIT to
select the left hand digit, and press the
down button to go below 0 to activate the
- sign. Press OK when done.
Set1
Set2 Output
Alarms
Digit
OK
Max/Min Reset
Done!
You may want to adjust a SCALE FACTOR value also, without affecting calibration. See
the separate SCALE page for this feature.
Press to accept
OFF
Circuit board ON
Press repeatedly until you see OF.St OF.St
OF.St OF.St OF.St
(4 digits) or
OFFSEt OFFSEt OFFSEt OFFSEt OFFSEt
(6 digits), followed
by the existing offset value. (Default is
000.0 000.0 000.0 000.0 000.0
fo 4 digits or
000.000 000.000 000.000 000.000 000.000
for 6 digits)