LAUREL Electronics MAGNA RS232, Инструкция по установке и эксплуатации

Страница: 22 / 35

22
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Factory Defaults
You can return the display to its factory default conditions whenever you wish. If you do so,
you will permanently loose all your settings and will need to start from the beginning again.
The calibration Audit Counter will NOT be reset, there is no way provided to reset this value,
as it is intended as a secure record to indicate whether changes have been made to the
display since it was last calibrated..
Lockout Switch must be OFF
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Press to accept
1
2
3
Done!
Press together for 3 seconds
OFF
Circuit board ON
Calibration Audit Number
Your display includes a non-resettable counter which increments each time you make a
change to the display’s calibration. This is useful if you want to check whether a display has
been altered since it was last calibrated.
The calibration audit number ranges from
CL.01 CL.01 CL.01 CL.01 CL.01
to
CL.FF CL.FF CL.FF CL.FF CL.FF
(4 digits) or
CAL.01 CAL.01 CAL.01 CAL.01 CAL.01
to
CAL.FF CAL.FF CAL.FF CAL.FF CAL.FF
(6 digits), allowing up to 255 alterations to be recorded. Whenever you want to check the
calibration audit number, press and hold the 2 outer buttons (Set1 + Alarms) for more than
3 seconds.
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Done!
1
Press together for 3 seconds
For “Defaults No”, the display shows
def.n def.n
def.n def.n def.n
(4 digits) or
defS.n defS.n
defS.n defS.n defS.n
(6 digits).
For “Default Yes” and to return to default
conditions, press the DOWN button to
change the display to
def.y def.y
def.y def.y
def.y
(4 digits)
or
defS.y defS.y
defS.y defS.y defS.y
(6 digits).