10
LAUNCH
CRP 429HD User's Manual
4. Initial Use
4.1 Charging CRP 429HD
There are two charging methods available:
Via Charging Cable: Plug one end of the included charging cable into the DC-IN
port of the tool, and the other end to the external DC power.
Via Diagnostic Cable: Insert one end of the diagnostic cable into the DB-15
connector of the tool, and the other end to the vehicle’s DLC (
*For vehicles
equipped with non-16pin DLC, a non-16pin adaptor cable is required
).
Once the charging LED illuminates solid green, it indicates that the battery is
fully charged.
4.2 Getting Started
If it is the first time you have used this tool, you need to make some system
settings.
1. Press the [Power] button to power it on.
2. The screen displays a welcome page. Tap “Start” to go to next step.
3. Choose the desired system language, and tap “Next”.
4. Choose the desired time zone, and tap “Next” to enter the WLAN setup page.
5. Slide the switch to ON, the system starts searching for all available wireless
LANs. Choose the desired WLAN access point / network,
• If the network you chose is open, you can connect directly;
• If the selected network is encrypted, you have to enter the right security
key (network password).
*Note: If you choose “Ignore” in WLAN setup, it will go into the date setting page. If
the tool has been properly connected to the Internet, the system will automatically
obtain the correct network date and time and navigate to step 6.
6. After the network connection is done, tap “Next” to configure email address.
Input the email address, and tap “Next” to navigate to the Job menu.
