Lauda Proline RP 1290 C, Руководство по эксплуатации

Страница: 21 / 120

Proline Edition X cooling thermostats
YACE0100 / October 4, 2018
Preparation
21
6 Preparation
6.1 Assembly and siting


Site the unit on a flat surface

The unit must not be put into operation if its
temperature during storage or transport has dropped
below the dew point.
Wait for about one hour.

The unit may NEVER be overturned nor put upside
down!

Do not cover the ventilation openings at the back of
the control head and on all sides of the lower section
of the unit.

Leave at least 40 cm of free space on all sides.

For operation as bath thermostat, set the bypass valve
to internal (without external loads) (

Section 3).

Plug the (high resistance) connector into the
corresponding socket 51H on the back of the control
head, the Bus-cable into the plug 70S and secure
both.

Only RP 890 C and RP 1290 C: In case of disturbing
dewing, connect the heating of the bath bridge. Plug
the supplied T-piece adaptor cable for the LAUDA
device bus into the 70S socket and secure it. Connect
it with the connection cable of the bath bridge heating.

Plug the bus connector of the Command console also
into the 70S socket or into the T-piece and secure it.

Further T-adaptors are available as accessories
EKS 073.

Avoid condensation of air humidity: Connect nitrogen
or dry air with a low volume flow for superposition to
the nipples of the bath covers of the minimum
temperature thermostats RP 890 C and RP 1290 C.
Operation with external loads
(Circulating thermostat) continue at (

6.4).

Check whether the pump connectors at the side and back are fitted with
sealing caps (

3) or that hoses are fitted for external loads.

With bath temperatures, over 70 °C the supplied self-adhesive label
should be applied on the bath at an easily visible point.

Do not carry out technical changes on the device!
In particular, it is not allowed to bore into the edges of the bath!


The unit can safely operate up to an ambient temperature of 40 °C.

An increased ambient temperature reduces the cooling capacity.